2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


INSPECT GENERATOR CLUTCH PULLEY

  1. A222451
    Hold the center of the generator clutch pulley and check that the outer ring turns counterclockwise and does not turn clockwise.
    Text in Illustration 
    V100135
    Free
    V100136
    Lock
    If the result is not as specified, replace the generator clutch pulley.


INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

  1. A128079E05
    Using a vernier caliper, measure the brush length.
    Text in Illustration 
    *a
    Length

    Standard exposed length:
    9.5 to 11.5 mm (0.374 to 0.453 in.)

    Minimum exposed length:
    4.5 mm (0.177 in.)

    If the brush length is less than the minimum, replace the generator brush holder assembly.


INSPECT GENERATOR ROTOR ASSEMBLY

  1. A079306E02
    Check that the generator rotor bearing is not rough or worn.
    If necessary, replace the generator rotor assembly.

  1. B012264E24
    Check the generator rotor for an open circuit.

    1. Measure the resistance according to the value(s) in the table below.

      Text in Illustration 
      *1
      Slip Ring

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip Ring - Slip Ring
      20°C (68°F)
      2.3 to 2.7 Ω

      If the result is not as specified, replace the generator rotor assembly.

  1. B012265E19
    Check if the generator rotor is grounded.

    1. Measure the resistance according to the value(s) in the table below.

      Text in Illustration 
      *1
      Slip Ring
      *2
      Rotor Core

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Slip Ring - Rotor Core
      Always
      10 MΩ or higher

      If the result is not as specified, replace the generator rotor assembly.

  1. A124106E05
    Using a vernier caliper, measure the slip ring diameter.
    Text in Illustration 
    *a
    Diameter

    Standard diameter:
    14.2 to 14.4 mm (0.559 to 0.567 in.)

    Minimum diameter:
    14.0 mm (0.551 in.)

    If the diameter is less than the minimum, replace the generator rotor assembly.


INSPECT GENERATOR DRIVE END FRAME BEARING

  1. A128080
    Check that the drive end frame bearing is not rough or worn.
    If necessary, replace the generator drive end frame bearing.

← INSPECTION (Jul 2007 – Jul 2009)REASSEMBLY (Jul 2007 – Jul 2009) →