2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

3. REMOVE BATTERY HOLD DOWN CLAMP

  1. A226647
    Loosen the 2 nuts and remove the battery hold down clamp.


4. REMOVE BATTERY

5. REMOVE BATTERY TRAY

6. REMOVE V-BANK COVER

  1. A229925E04
    Raise the front of the V-bank cover to disengage the 2 cushions of the V-bank cover from the 2 pins.
    Text in Illustration 
    *1
    Cushion
    *2
    Pin
    *3
    Hook
    *4
    No. 1 V-bank Cover Bracket

  1. Disengage the 2 hooks to remove the V-bank cover from the No. 1 V-bank cover bracket.


7. REMOVE FAN AND GENERATOR V BELT

  1. A217571
    While turning the belt tensioner counterclockwise, align the service hole for the belt tensioner and the belt tensioner fixing position, and then insert a bar of φ 6 mm (0.236 in.) into the service hole to fix the belt tensioner in place.

    HINT:
    The pulley bolt for the belt tensioner has a left-hand thread.

  1. Remove the V belt.


8. REMOVE WIRING HARNESS CLAMP BRACKET

  1. A226648
    Disconnect the clamp.

  1. Remove the bolt and wire harness clamp bracket.


9. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR

  1. A221484
    Remove the 3 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold sub-assembly LH.


10. REMOVE FRONT FENDER APRON SEAL LH

  1. A223333
    Remove the 5 clips and front fender apron seal LH from the front fender apron sub-assembly LH.


11. REMOVE GENERATOR ASSEMBLY

  1. A222881
    Open the terminal cap.

  1. Remove the nut and disconnect the wire harness from terminal B.

  1. Disconnect the generator connector from the generator assembly.

  1. A222884
    Remove the 2 bolts and disconnect the wire harness.

  1. A222882
    Disconnect the wire harness clamp.

  1. Remove the bolt and disconnect the generator bracket from the cylinder block.

  1. A222883
    Remove the 2 bolts and generator assembly.

  1. A222885
    Remove the bolt and generator bracket.

← REMOVAL (Nov 2010 – Jul 2014)DISASSEMBLY (Jul 2007 – Jul 2009) →