2011-2016 FJ Cruiser · Service Manual ENGINE

DISASSEMBLY

Removal / installation · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. REMOVE GENERATOR PULLEY CAP

  1. A219656
    Using a screwdriver, remove the generator pulley cap.


2. REMOVE GENERATOR CLUTCH PULLEY
  1. Mount the generator in a vise between aluminum plates.

  1. A219555E01
    Install SST (A) and (B) to the generator with clutch pulley as shown in the illustration.
    SST
    09820-63021  
    Text in Illustration 
    *1
    Rotor Shaft

    NOTICE:
    Securely attach SST to the generator with clutch pulley and generator rotor shaft.

  1. A219556E01
    Use a wrench to hold SST (A) and turn SST (B) counterclockwise to loosen the generator with clutch pulley.

    NOTICE:
    Be careful as the generator with clutch pulley or generator rotor shaft may be damaged if the position of SST is not securely maintained while performing this operation.

    Text in Illustration 
    *a
    Hold
    V100135
    Turn

  1. Remove SST from the generator.

  1. Remove the generator with clutch pulley from the rotor shaft.


3. REMOVE GENERATOR REAR END COVER

  1. A221621
    Remove the nut and cord clamp.

  1. A220458
    Remove the 3 nuts and generator rear end cover.


4. REMOVE GENERATOR TERMINAL INSULATOR

  1. A219659
    Remove the terminal insulator from the generator coil.


5. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY

  1. A219660
    Remove the 2 screws and brush holder from the generator coil.


6. REMOVE GENERATOR COIL ASSEMBLY

  1. A219661
    Remove the 4 bolts.

  1. A219662E01
    Using SST, remove the generator coil.
    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)
    Text in Illustration 
    *a
    Hold
    V100135
    Turn


7. REMOVE GENERATOR ROTOR ASSEMBLY

  1. A118365E01
    Remove the generator washer.

  1. A219665
    Remove the generator rotor assembly.


8. REMOVE GENERATOR DRIVE END FRAME BEARING

  1. A223426
    Remove the 4 screws and retainer plate from the drive end frame.

  1. A128077E01
    Using SST and a hammer, tap out the drive end frame bearing from the drive end frame.
    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)

← DISASSEMBLY (Jul 2007 – Jul 2009)INSPECTION (Jul 2007 – Jul 2009) →