2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012


1. INSTALL ULTRASONIC SENSOR RETAINER

  1. E135552E01
    Install the ultrasonic sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.


2. INSTALL ULTRASONIC SENSOR

  1. E161335
    Engage the 2 claws and install the ultrasonic sensor.

  1. Connect the sensor connector.


3. INSTALL REAR BUMPER EXTENSION MOULDING LH

  1. B190465
    Engage the 4 claws and install the rear bumper extension moulding.


4. INSTALL REAR BUMPER EXTENSION MOULDING RH

HINT:
Use the same procedure as for the LH side.


5. INSTALL REAR FOG LIGHT ASSEMBLY LH

E161251
  1. Install the rear fog light with the 2 screws.

  1. Connect the 2 connectors and wire harness clamp.


6. INSTALL REAR FOG LIGHT ASSEMBLY RH

E161252
  1. Install the rear fog light with the 2 screws.

  1. Connect the 2 connectors and wire harness clamp.


7. INSTALL REAR BUMPER SIDE RETAINER RH

E161885
  1. Install the rear bumper extension retainer with the 3 screws.


8. INSTALL REAR BUMPER SIDE RETAINER LH

HINT:
Use the same procedure as for the RH side.


9. CONNECT FLOOR WIRE

B190463
  1. Connect the 9 wire harness clamps.

  1. Connect the 8 connectors.


10. INSTALL REAR BUMPER COVER

  1. B190460
    Engage the 6 claws and the 2 clips and install the rear bumper cover.

  1. B198721
    Engage the harness clamp, and connect the connector.

  1. B135141
    Tighten the 7 bolts and the 2 screws.

    Torque:
    8.0 N*m{ 80 kgf*cm , 71 in.*lbf } for bolt
    3.0 N*m{ 30 kgf*cm , 27 in.*lbf } for screw

  1. B198720
    Install the clip.

    HINT:
    Use the same procedure for the RH side and LH side.

  1. B190458
    Remove the protective tape.

← REMOVAL (from Nov 2012)INSTALLATION (Nov 2010 – Jul 2012) →