2011-2016 FJ Cruiser · Service Manual COMMUNICATION SYSTEM

Open in CAN Main Wire

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

DESCRIPTION

There may be an open circuit in the CAN main wire and/or the DLC3 branch wire when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is 69 Ω or more.
Symptom
Trouble Area
Resistance between terminals 6 (CANH) and 14 (CANL) of DLC3 is 69 Ω or more.
  1. CAN main wire or connector
  2. ECM
  3. CAN J/C

WIRING DIAGRAM

C133852E01

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
  2. After the ignition switch is turned off, check that the key reminder warning system is not in operation.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

    HINT:
    Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. CHECK DLC3

  1. C118856E45
    Turn the ignition switch OFF.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    Proceed to
    E1-6 (CANH) - E1-14 (CANL)
    Ignition switch OFF
    108 to 132 Ω
    A
    E1-6 (CANH) - E1-14 (CANL)
    Ignition switch OFF
    132 Ω or higher
    B

    NOTICE:
    When the measured value is 132 Ω or more and a CAN communication system diagnostic trouble code is output, there may be a fault besides disconnection of the DLC3 branch wire. For that reason, troubleshooting should be performed again from "HOW TO PROCEED WITH TROUBLESHOOTING" (Click here) after repairing the trouble area.



B
REPAIR OR REPLACE CAN BRANCH WIRE CONNECTED TO DLC3 (CAN-H, CAN-L)
A


2. CHECK CAN MAIN WIRE FOR DISCONNECTION (ECM)

  1. C132870E01
    Disconnect the E46 ECM connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E46-33 (CANH) - E46-34 (CANL)
    Ignition switch OFF
    108 to 132 Ω



OK
REPLACE ECM (Click here)
NG


3. CONNECT CONNECTOR
  1. Reconnect the ECM connector.


NEXT


4. INSPECT CAN J/C

  1. C133849E01
    Disconnect the E62 CAN main wire connector.

    NOTICE:
    1. Before disconnecting the connector, make a note of where it is connected.
    2. Reconnect the connector to its original position.

  1. C133851E01
    Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    CANH - CANL
    Ignition switch OFF
    108 to 132 Ω



NG
REPLACE CAN J/C
OK

REPAIR OR REPLACE CAN MAIN WIRE OR CONNECTOR (ECM - CAN J/C (CAN-H, CAN-L))


← CAN Bus Line (Aug 2009 – Oct 2010)Open in CAN Main Bus Line (LHD Models) (from Nov 2010) →