REMOVAL
Removal / installation · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
| 1.
REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)
|
 |
Disconnect the sensor connector.
- Using SST, remove the sensor.
- SST
- 09224-00010
| 2.
REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)
|
 |
Disconnect the sensor connector.
- Using SST, remove the sensor.
- SST
- 09224-00010
| 3.
REMOVE TAIL EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 bolts and separate the exhaust pipe support, then remove the tail exhaust pipe.
| 4.
REMOVE CENTER EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 bolts and 2 compression springs, then separate the center exhaust pipe.
Separate the 4 exhaust pipe supports from the center exhaust pipe, then remove the center exhaust pipe.
| 5.
REMOVE EXHAUST PIPE STOPPER BRACKET |
 |
- Remove the 2 bolts, then remove the exhaust pipe stopper bracket.
| 6.
REMOVE NO. 2 FRONT EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 bolts and 2 nuts and separate the exhaust pipe support, then remove the No. 2 front exhaust pipe.
Remove the front exhaust pipe gasket.
| 7.
REMOVE MONOLITHIC CONVERTER PROTECTOR |
 |
- Remove the bolt and clamp.
Remove the 2 bolts and 2 nuts, and then remove the monolithic converter protector.
| 8.
REMOVE CONVERTER PROTECTOR STAY LH |
|
| 9.
REMOVE EXHAUST PIPE GASKET |
 |
Remove the exhaust pipe gasket from the front exhaust pipe assembly.
| 10.
REMOVE FRONT EXHAUST PIPE ASSEMBLY |
 |
- Remove the 2 nuts, then remove the front exhaust pipe.
Remove the front exhaust pipe gasket.
| 11.
REMOVE MONOLITHIC CONVERTER PROTECTOR (w/ Heat Insulator) |
 |
- Remove the bolt and clamp.
Remove the 2 bolts and 2 nuts, and then remove the monolithic converter protector.
| 12.
REMOVE CONVERTER PROTECTOR STAY LH (w/ Heat Insulator) |
|