2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014


1. INSTALL GENERATOR ASSEMBLY

A129940
  1. Install the generator assembly with the 2 bolts.

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }

  1. A129942
    Install the wire harness clamp bracket with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Connect the wire harness.

    1. A129941
      Connect the wire harness to terminal B and install the nut.

      Torque:
      10 N*m{ 100 kgf*cm , 7 ft.*lbf }

    2. Connect the connector to the generator assembly.

    3. A076407E01
      Install the wire harness stay with the bolt.

      Torque:
      5.8 N*m{ 59 kgf*cm , 51 in.*lbf }


2. INSTALL FAN & GENERATOR V BELT

A076442E04
  1. While turning the belt tensioner counterclockwise, align the holes as shown, and then insert a bar of 6 mm (0.24 in.) into the holes to fix the belt tensioner.

  1. Install the V-ribbed belt.

    A126493E01

  1. While turning the belt tensioner counterclockwise, remove the bar.

  1. If it is hard to install the V-ribbed belt, perform the following procedure:

    1. Put the V-ribbed belt on all parts except the P/S pump, as shown in the illustration.

    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the V-ribbed belt on the P/S pump.


3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Install the No. 1 engine under cover with the 4 bolts.

    Torque:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }


4. INSTALL V-BANK COVER

  1. A126475
    Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }


5. INSTALL BATTERY

Torque:
3.9 N*m{ 40 kgf*cm , 35 in.*lbf }

← REASSEMBLY (from Aug 2009)INSTALLATION (Aug 2009 – Oct 2010) →