2011-2016 FJ Cruiser · Service Manual BODY

INSTALLATION

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Jul 2007 – Jul 2013 Aug 2013 – Jul 2014 from Aug 2014


1. INSTALL FRONT BUMPER EXTENSION LH
  1. Install the front bumper extension LH with the 4 nuts.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }


2. INSTALL FRONT BUMPER EXTENSION RH

HINT:
Use the same procedure as for the LH side.


3. INSTALL FRONT SUSPENSION MEMBER DAMPER ASSEMBLY (w/ Performance Damper)
  1. Install the front suspension member damper assembly with the 2 nuts.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }

    NOTICE:
    Do not compress or extend the front suspension member damper assembly or rotate the rod.


4. INSTALL FRONT BUMPER REINFORCEMENT
  1. Install the front bumper reinforcement with the 4 nuts.

    Torque:
    65 N*m{ 663 kgf*cm , 48 ft.*lbf }


5. INSTALL FRONT BUMPER UPPER RETAINER
  1. Engage the 2 hooks to install the front bumper upper retainer.

  1. Install the 3 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


6. INSTALL FRONT BUMPER FILLER LH
  1. Engage the clip and 2 claws to install the front bumper filler LH.


7. INSTALL FRONT BUMPER FILLER RH

HINT:
Use the same procedure as for the LH side.


8. INSTALL FRONT BUMPER SIDE SUPPORT LH
  1. Engage the 2 claws to install the front bumper side support LH.

  1. Install the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }


9. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure as for the LH side.


10. INSTALL FRONT BUMPER ASSEMBLY
  1. Install the 4 clips.

  1. w/o Fog Light:

    1. Engage the 2 claws to install the front bumper assembly.

  1. w/ Fog Light:

    1. Connect the connector.

    2. Engage the 2 claws to install the front bumper assembly.

  1. Install the 8 screws and 4 bolts.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf } for screw
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf } for bolt

  1. Install the 5 clips.

  1. Remove the protective tape.


11. INSTALL RADIATOR GRILLE
  1. Engage the 5 clips and install the radiator grille.

  1. Install the 2 screws.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }

  1. Install the 2 clips.


12. ADJUST FOG LIGHT AIMING
(Click here)
← INSTALLATION (Aug 2013 – Jul 2014)COMPONENTS (Jul 2007 – Oct 2010) →