REMOVAL
Removal / installation · Vehicles built Nov 2010 – Oct 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Oct 2012 from Nov 2012
| 1.
REMOVE REAR BUMPER COVER |
 |
- Apply protective tape as shown in the illustration.
Text in Illustration
*1
|
Protective Tape
|
- Remove the 7 bolts and the 2 screws.
- Disengage the clamp.
Disconnect the connector.
- HINT:
- If the vehicle is equipped with back sonar, disconnect the connector and floor wire.
- Disengage the 6 claws and the 2 clips and remove the rear bumper cover.
| 2.
REMOVE REAR BUMPER END RETAINER LH |
 |
- Remove the screw.
Disengage the 2 claws and remove the rear bumper end retainer.
| 3.
REMOVE REAR BUMPER END RETAINER RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 4.
REMOVE REAR BUMPER UPPER RETAINER LH |
 |
- Remove the 2 screws.
Disengage the 3 claws and remove the rear bumper upper retainer.
| 5.
REMOVE REAR BUMPER UPPER RETAINER RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 6.
REMOVE REAR BUMPER ENERGY ABSORBER |
 |
- Disengage the 2 claws and remove the rear bumper energy absorber.
| 7.
REMOVE REAR BUMPER SIDE STAY LH |
 |
- Remove the bolt and the rear bumper side stay.
| 8.
REMOVE REAR BUMPER SIDE STAY RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 9.
REMOVE REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY LH |
 |
- Remove the 2 bolts and the rear bumper side support.
| 10.
REMOVE REAR BUMPER SIDE SUPPORT SUB-ASSEMBLY RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 11.
REMOVE REAR BUMPER BAR BRACKET LH |
 |
- Remove the bolt and the rear bumper bar bracket.
| 12.
REMOVE REAR BUMPER BAR BRACKET RH |
 |
- HINT:
- Use the same procedure as for the LH side.