2011-2016 FJ Cruiser · Service Manual BODY

DISASSEMBLY

Removal / installation · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. REMOVE FLOOR WIRE (w/ Back Sonar)

B135145E01

HINT:
Use the same procedure for both sides.

  1. Using a clip remover, remove the 3 clamps.

  1. Disconnect the ultrasonic sensor connector and remove the floor wire.


2. REMOVE ULTRASONIC SENSOR (w/ Back Sonar)

B135146E01

HINT:
Use the same procedure for both sides.

  1. Remove the retainer and the ultrasonic sensor as shown in the illustration.


3. REMOVE REAR BUMPER PAD LH

  1. B135148
    Remove the 5 retainers.

  1. Disengage the 5 claws and remove the rear bumper pad.


4. REMOVE REAR BUMPER PAD RH

HINT:
Use the same procedure as for the LH side.


5. REMOVE REFLEX REFLECTOR ASSEMBLY LH

  1. B135149
    Remove the nut and the reflex reflector.


6. REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:
Use the same procedure as for the LH side.


7. REMOVE REAR BUMPER LOWER COVER

  1. B135150
    Remove the 4 screws.

  1. Disengage the 4 clips and remove the rear bumper lower cover.

  1. B135151
    Remove the 4 screw grommets.

← REMOVAL (from Nov 2012)DISASSEMBLY (from Nov 2010) →