DISASSEMBLY
Removal / installation · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
| 1.
REMOVE NO. 8 FLOOR WIRE (w/ Back Sonar) |
 |
Disconnect the 2 connectors.
Disengage the 7 clamps and remove the floor wire.
| 2.
REMOVE NO. 1 ULTRASONIC SENSOR (w/ Back Sonar) |
 |
- Disengage the 2 claws and remove the ultrasonic sensor.
- HINT:
- Use the same procedure for the remaining parts.
| 3.
REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Back Sonar) |
 |
- Disengage the 2 claws and remove the ultrasonic sensor retainer.
- HINT:
- Use the same procedure for the remaining parts.
| 4.
REMOVE REAR BUMPER PAD LH |
 |
- Remove the 5 retainers.
Disengage the 5 claws and remove the rear bumper pad.
| 5.
REMOVE REAR BUMPER PAD RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 6.
REMOVE REFLEX REFLECTOR ASSEMBLY LH |
 |
- Remove the nut and the reflex reflector.
| 7.
REMOVE REFLEX REFLECTOR ASSEMBLY RH |
 |
- HINT:
- Use the same procedure as for the LH side.
| 8.
REMOVE REAR BUMPER LOWER COVER |
 |
- Remove the 4 screws.
Disengage the 4 clips and remove the rear bumper lower cover.
- Remove the 4 screw grommets.