REMOVAL
Removal / installation · Vehicles built from Jul 2007
- HINT:
- The procedure described below is for the LH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT DOOR ARMREST BASE UPPER PANEL |
- HINT:
- Use the same procedure as for the RH side (Click here).
| 3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
- HINT:
- Use the same procedure as for the RH side (Click here).
| 4. REMOVE FRONT DOOR NO. 2 SERVICE HOLE COVER |
- HINT:
- Use the same procedure as for the RH side (Click here).
| 5. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY |
for Driver Side:

Provisionally install the power window regulator master switch.
for Front Passenger Side:
Provisionally install the power window regulator switch.
Close the door glass.
Disconnect the connector.
Remove the 3 bolts and the outer rear view mirror.
- NOTICE:
- Do not drop or damage the outer rear view mirror when removing the bolts.
| 6. REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY |
Apply protective tape to the front door panel in the area around the front door glass outer weatherstrip.

Using a moulding remover, disengage the 8 claws and remove the front door glass outer weatherstrip.

