INSPECTION
Inspection · Vehicles built Jul 2007 – Jul 2009
Versions by build date: Jul 2007 – Jul 2009 from Aug 2009
| INSPECT DUTY VACUUM SWITCHING VALVE |
Check the resistance.

Using an ohmmeter, measure the resistance between the terminals.
- Standard resistance:
Tester Connection
Specified Condition
1 - 2
26 to 30 Ω at 20°C (68°F)
Check vacuum switching valve No. 1 for ground.

Using an ohmmeter, check the resistance between each terminal and the body.
- Standard resistance:
Tester Connection
Specified Condition
1 - Body
10 MΩ or higher
2 - Body
10 MΩ or higher
Check the operation.

Check that air does not flow from port E to port F.
If the operation is not as specified, replace vacuum switching valve No. 1.
Apply battery voltage across the terminals.

Check that air flows from port E to port F.
If the operation is not as specified, replace vacuum switching valve No. 1.
