2011-2016 FJ Cruiser · Service Manual ENGINE

REASSEMBLY

Removal / installation · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. INSTALL FUEL MAIN VALVE ASSEMBLY

  1. A223172E02
    Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve.
    Text in Illustration 
    *1
    New O-ring

  1. Install the fuel main valve to the fuel filter case.

    NOTICE:
    Make sure the O-rings are not cut or pinched during the installation.


2. INSTALL FUEL PUMP

  1. A223260E02
    Connect the fuel pump wire harness connector to the fuel pump.
    Text in Illustration 
    *1
    New O-ring
    *2
    Fuel Pump Spacer

  1. Apply a light coat of gasoline to a new O-ring. Then install the fuel pump spacer and O-ring to the fuel pump.

  1. A223259E01
    Engage the 5 claws and install the fuel pump onto the fuel filter case.
    Text in Illustration 
    *1
    Fuel Filter Case


3. INSTALL NO. 1 FUEL SUB-TANK

  1. A223171
    Engage the 3 claws.

  1. A223170
    Engage the 3 claws and install the No. 1 fuel sub-tank.

  1. A223268E02
    Install the tube part to the No. 1 fuel sub-tank.
    Text in Illustration 
    *1
    Jet Pump

  1. Connect the jet pump to the No. 1 fuel sub-tank.

  1. Connect the fuel pump connector.


4. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A223133E01
    Set the fuel sender gauge to the fuel sub-tank. Then slide the fuel sender gauge downward to install it.
    Text in Illustration 
    *1
    Fuel Sub-tank
    V100135
    Slide

  1. Connect the fuel sender gauge connector.

← REASSEMBLY (Jul 2007 – Jul 2009)INSTALLATION (Jul 2007 – Jul 2009) →