2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Clearance Warning Buzzer Circuit

Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

The clearance warning ECU receives the ultrasonic sensor signal to sound the clearance warning buzzer.

WIRING DIAGRAM

E160763E01

INSPECTION PROCEDURE


1. INSPECT CLEARANCE WARNING BUZZER

  1. B138426E01
    Remove the clearance warning buzzer.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Always
    approximately 1 kΩ

  1. Reinstall the clearance warning buzzer.



NG
REPLACE CLEARANCE WARNING BUZZER (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING BUZZER - CLEARANCE WARNING ECU)

  1. E160764E01
    Disconnect the E10 clearance warning buzzer connector.

  1. Disconnect the E31 or E76 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E10-1 - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    w/o Rear Fog Light 
    Tester Connection
    Condition
    Specified Condition
    E10-2 - E31-2 (BBZ)
    Always
    Below 1 Ω
    w/ Rear Fog Light 
    Tester Connection
    Condition
    Specified Condition
    E10-2 - E76-12 (BBZ)
    Always
    Below 1 Ω

  1. Reconnect the clearance warning buzzer connector.

  1. Reconnect the clearance warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Sonar Main Switch Circuit (from Nov 2010)Clearance Warning Buzzer Circuit (from Nov 2010) →