2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Clearance Sonar Main Switch Circuit

Circuit diagnosis · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

Turning this switch on activates the Toyota parking assist-sensor system.

WIRING DIAGRAM

B268489E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT BACK SONAR SWITCH ASSEMBLY
  1. Inspect the back sonar switch assembly (Click here).



NG
REPLACE BACK SONAR SWITCH ASSEMBLY (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (BACK SONAR SWITCH ASSEMBLY - CLEARANCE WARNING ECU)
  1. Disconnect the E12 back sonar switch assembly connector.

  1. Disconnect the E76 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E12-3 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E12-4 (ECU) - E76-10 (IG)
    Always
    Below 1 Ω
    E12-6 (E) - Body ground
    E76-21 (E) - Body ground

  1. Reconnect the back sonar switch connector.

  1. Reconnect the clearance warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3. INSPECT CLEARANCE WARNING ECU ASSEMBLY

  1. B268888E01
    Remove the clearance warning ECU with its connector still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E76-10 (IG) - E76-21 (E)
    Ignition switch ON, back sonar switch ON
    11 to 14 V

    Text in Illustration 
    *a
    Component with harness connected
    (Clearance Warning ECU)

  1. Reinstall the clearance warning ECU.



NG
REPLACE CLEARANCE WARNING ECU ASSEMBLY (Click here)
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Sonar Main Switch Circuit (Jul 2007 – Oct 2010)Clearance Warning Buzzer Circuit (Jul 2007 – Oct 2010) →