2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Clearance Warning Buzzer Circuit

Circuit diagnosis · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

The clearance warning ECU receives the ultrasonic sensor signal to sound the clearance warning buzzer.

WIRING DIAGRAM

B268491E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT CLEARANCE WARNING BUZZER
  1. Inspect the clearance warning buzzer (Click here).



NG
REPLACE CLEARANCE WARNING BUZZER (Click here)
OK


2. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING BUZZER - CLEARANCE WARNING ECU)
  1. Disconnect the E10 clearance warning buzzer connector.

  1. Disconnect the E76 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    E10-1 - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E10-2 - E76-12 (BBZ)
    Always
    Below 1 Ω

  1. Reconnect the clearance warning buzzer connector.

  1. Reconnect the clearance warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Clearance Warning Buzzer Circuit (Jul 2007 – Oct 2010)PARTS LOCATION (from Aug 2008) →