2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Washer Motor Circuit

Circuit diagnosis · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010

DESCRIPTION

The main body ECU controls the rear washer motor.

WIRING DIAGRAM

E152592E01

INSPECTION PROCEDURE


1. INSPECT FUSE (RR WSH)
  1. Remove the RR WSH fuse from the main body ECU.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    RR WSH fuse
    Always
    Below 1 Ω

  1. Reinstall the RR WSH fuse.



NG
REPLACE FUSE
OK


2. INSPECT WINDSHIELD WASHER MOTOR ASSEMBLY
B136064
  1. Disconnect the rear washer motor assembly connector.

  1. Connect the battery's positive (+) lead to terminal 1 and the negative (-) lead to terminal 2.

  1. Check that the rear washer motor operates.

    OK:
    Rear washer motor operates.

  1. Reconnect the rear washer motor assembly connector.



NG
REPLACE WINDSHIELD WASHER MOTOR ASSEMBLY (Click here)
OK


3. CHECK HARNESS AND CONNECTOR (REAR WASHER MOTOR - MAIN BODY ECU, BODY GROUND)
B136066E01
  1. Disconnect the rear washer motor assembly connector.

  1. Disconnect the 1B main body ECU connector.

  1. Measure the resistance.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1B-1 (WMTR) - Rear washer motor assembly connector 1
    Always
    Below 1 Ω
    1B-1 (WMTR) - Body ground
    Always
    10 kΩ or higher
    Rear washer motor assembly connector 2 - Body ground
    Always
    Below 1 Ω

  1. Reconnect the rear washer motor assembly connector.

  1. Reconnect the main body ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE MAIN BODY ECU


← Wiper and Washer Switch Circuit (from Jul 2007)Washer Motor Circuit (Aug 2009 – Oct 2010) →