Washer Motor Circuit
Circuit diagnosis · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010
DESCRIPTION
The main body ECU controls the rear washer motor.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT REAR WASHER MOTOR AND PUMP ASSEMBLY |
Inspect the rear washer motor and pump assembly (Click here).
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (REAR WASHER MOTOR AND PUMP ASSEMBLY - MAIN BODY ECU, BODY GROUND) |
Disconnect the A38 rear washer motor and pump assembly connector.
Disconnect the 1B main body ECU connector.
Measure the resistance.
- Standard resistance:
Tester Connection
Condition
Specified Condition
1B-1 (WMTR) - A38-1 (B)
Always
Below 1 Ω
1B-1 (WMTR) - Body ground
Always
10 kΩ or higher
A38-2 (SW) - Body ground
Always
Below 1 Ω
Reconnect the rear washer motor and pump assembly connector.
Reconnect the main body ECU connector.
|
|
||||
| OK | ||
| ||
