Skid Control ECU Communication Stop Mode
Circuit diagnosis · Vehicles built Jul 2007 – Oct 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
DESCRIPTION
| Detection Item |
Symptom |
Trouble Area |
| Skid Control ECU Communication Stop Mode |
|
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
- After the ignition switch is turned off, check that the key reminder warning system is not in operation.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.
- HINT:
- Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.
- Turn the ignition switch off before measuring the resistances of the CAN main wire and the CAN branch wire.
| 1. CHECK CAN BUS LINE FOR DISCONNECTION (SKID CONTROL ECU BRANCH WIRE) |
Turn the ignition switch OFF.

Disconnect the A4 skid control ECU connector.
Measure the resistance.
- Standard resistance:
Tester connection
Condition
Specified Condition
A4-11 (CANH) - A4-25 (CANL)
Ignition switch OFF
54 to 69 Ω
|
|
||||
| OK | |
| 2. CHECK HARNESS AND CONNECTOR (IG1, GND2) |
Disconnect the A4 skid control ECU connector.

Measure the resistance.
- Standard resistance:
Tester connection
Condition
Specified Condition
A4-32 (GND2) - Body ground
Always
Below 1 Ω
Measure the voltage.
- Standard voltage:
Tester connection
Condition
Specified Condition
A4-46 (IG1) - Body ground
Ignition switch ON
11 to 14 V
|
|
||||
| OK | ||
| ||
