2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 from Nov 2010


1. INSTALL CRANKSHAFT POSITION SENSOR

  1. A226976E01
    Apply a light coat of engine oil to the O-ring of the sensor.
    Text in Illustration 
    *1
    O-Ring

    NOTICE:
    1. When reusing the sensor, inspect the O-ring.
    2. If the O-ring has scratches or cuts, replace the sensor.

  1. Install the sensor with the bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Connect the sensor connector.


2. INSTALL COOLER COMPRESSOR ASSEMBLY

A225903E01
  1. Temporarily install the cooler compressor with the 3 bolts.

  1. Install the stud bolt.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

  1. Install the nut.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }

  1. Fully tighten the 3 bolts in the order shown in the illustration.

    Torque:
    25 N*m{ 250 kgf*cm , 18 ft.*lbf }

  1. Install the suction hose with the bolt.

    Torque:
    7.8 N*m{ 80 kgf*cm , 69 in.*lbf }


3. INSTALL GENERATOR ASSEMBLY
  1. Install the generator (Click here).

← INSTALLATION (Jul 2007 – Jul 2009)INSTALLATION (from Nov 2010) →