2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


INSPECT STEERING PAD SWITCH ASSEMBLY

  1. Check the resistance.

    E219811E02

    Text in Illustration 
    *a
    Volume+
    *b
    Volume-
    *c
    Seek-
    *d
    MODE
    *e
    Seek+
    *f
    Off Hook
    *g
    On Hook
    *h
    Voice
    *i
    Component without harness connected
    (Steering Pad Switch Assembly)
    -
    -

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      12 (AU1) - 10 (EAU)
      No switch is pushed
      95 to 105 kΩ
      Seek+ switch pushed
      Below 2.5 Ω
      Seek- switch pushed
      312 to 345 Ω
      Volume+ switch pushed
      950 to 1050 Ω
      Volume- switch pushed
      2954 to 3265 Ω
      11 (AU2) - 10 (EAU)
      No switch is pushed
      95 to 105 kΩ
      MODE switch pushed
      Below 2.5 Ω
      On hook switch pushed
      312 to 345 Ω
      Off hook switch pushed
      950 to 1050 Ω
      Voice switch pushed
      2954 to 3265 Ω

      If the result is not as specified, replace the steering pad switch.

  1. Check the operation.

    E219841E02

    Text in Illustration 
    *a
    Component without harness connected
    (Steering Pad Switch Assembly)
    -
    -

    1. Apply battery voltage to the terminals and check that the indicator illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) - Terminal 1 (ILL+)
      Battery negative (-) - Terminal 10 (EAU)
      Illuminates

      If the result is not as specified, replace the steering switch.

← INSPECTION (Jul 2007 – Oct 2010)INSTALLATION (Jul 2007 – Oct 2010) →