REMOVAL
Removal / installation · Vehicles built Nov 2010 – Jul 2014
Versions by build date: Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014
| 1.
REMOVE FAN SHROUD |
 |
Remove the fan shroud (Click here).
| 2.
SEPARATE WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler) |
 |
Remove the 3 bolts.
- Disconnect the 2 hoses and separate the water by-pass pipe.
| 3.
REMOVE OIL FILTER BRACKET
|
 |
Remove the 2 nuts, bolt, oil filter bracket and gasket.
Text in Illustration
*A
|
w/ Oil Cooler:
|
*B
|
w/o Oil Cooler:
|
| 4.
REMOVE CRANKSHAFT PULLEY
|
 |
Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.
- SST
- 09213-54015
(91651-60855)
09330-00021
- Using the pulley set bolt and SST, remove the crankshaft pulley and pulley bolt.
- SST
- 09950-50013
(09951-05010, 09952-05010, 09953-05020, 09954-05031)
| 5.
REMOVE FRONT CRANKSHAFT OIL SEAL |
 |
Using a screwdriver, pry out the oil seal.
- NOTICE:
- Do not damage the surface of the oil seal press fit hole and crankshaft.
- HINT:
- Tape the screwdriver tip before use.