2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014


1. REMOVE FAN SHROUD
  1. Remove the fan shroud (Click here).


2. SEPARATE WATER BY-PASS PIPE SUB-ASSEMBLY (w/ Oil Cooler)

A225377
  1. Remove the 3 bolts.

  1. A222108
    Disconnect the 2 hoses and separate the water by-pass pipe.


3. REMOVE OIL FILTER BRACKET

A223672E01
  1. Remove the 2 nuts, bolt, oil filter bracket and gasket.

    Text in Illustration 
    *A
    w/ Oil Cooler:
    *B
    w/o Oil Cooler:


4. REMOVE CRANKSHAFT PULLEY

A072947E06
  1. Using SST, hold the crankshaft pulley and loosen the pulley bolt. Further loosen the bolt until 2 or 3 threads are screwed into the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A072948E04
    Using the pulley set bolt and SST, remove the crankshaft pulley and pulley bolt.
    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05031)


5. REMOVE FRONT CRANKSHAFT OIL SEAL

A221099
  1. Using a screwdriver, pry out the oil seal.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (Nov 2010 – Jul 2014)INSTALLATION (Aug 2009 – Jul 2011) →