2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2010

Versions by build date: Aug 2009 – Oct 2010 from Nov 2010


1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)
  1. Remove the manual unit transmission (Click here).


2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)
  1. Remove the automatic transmission (Click here).


3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

C135775E02
  1. Align the matchmark on the clutch cover assembly with the one on the flywheel sub-assembly.

    Text in Illustration 
    *a
    Matchmark

  1. Loosen each set bolt one turn at a time until the spring tension is released.

  1. Remove the 6 bolts and clutch cover assembly.

    NOTICE:
    Do not drop the clutch disc assembly.


4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

NOTICE:
Keep the lining part of the clutch disc assembly, pressure plate and surface of the flywheel sub-assembly free from oil and foreign matter.


5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

A224775E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A224776
    Remove the 8 bolts and flywheel.


6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

A224775E01
  1. Using SST, hold the crankshaft.

    SST
    09213-54015   (91651-60855)
    09330-00021  

  1. A224777
    Remove the 8 bolts, rear spacer, drive plate and ring gear and front spacer.


7. REMOVE REAR CRANKSHAFT OIL SEAL
  1. Using a knife, cut off the lip of the oil seal.

  1. A076328E03
    Using a screwdriver, pry out the oil seal.
    Text in Illustration 
    *1
    Cut Position

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.

    HINT:
    Tape the screwdriver tip before use.

← REMOVAL (Aug 2009 – Oct 2010)INSTALLATION (Aug 2009 – Oct 2010) →