2011-2016 FJ Cruiser · Service Manual SECURITIES

B2799 Engine Immobiliser System Malfunction

Diagnostic trouble codes · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009

DESCRIPTION

This DTC is output when one of the following occurs: 1) the ECM detected errors in its own communications with the transponder key ECU; 2) the ECM detects errors in the communication lines; or 3) the ECU communication ID between the transponder key ECU and ECM is different and an engine start is attempted. Before troubleshooting for this DTC, make sure no transponder key ECU DTCs are present. If present, troubleshoot the transponder key ECU DTCs first.
DTC No.
DTC Detection Condition
Trouble Area
B2799
One of following conditions is met:
  1. Error in communication between ECM and transponder key ECU
  2. Error in communication lines
  3. Communication ID is different during communication with transponder key ECU
  1. Wire harness
  2. ECM
  3. Transponder key ECU

WIRING DIAGRAM

B175508E04

INSPECTION PROCEDURE


1. CHECK DTC OUTPUT
  1. Delete the DTC (Click here).

  1. Recheck for DTC (Click here).

    OK:
    DTC B2799 output does not reoccur.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)

2. ECU CODE REGISTRATION
  1. Re-register the ECU communication ID between the transponder key ECU and ECM (Refer to the Service Bulletin).


NEXT


3. CHECK DTC OUTPUT
  1. Delete the DTC (Click here).

  1. Recheck for DTC (Click here).

    OK:
    DTC B2799 output does not reoccur.



NG
Go to step 4
OK

END

4. CHECK CONNECTION OF CONNECTOR
  1. Turn the ignition switch OFF.

  1. Check that the connectors are properly connected to the ECM and the transponder key ECU.

    OK:
    Connectors are properly connected.



NG
CONNECT CONNECTORS PROPERLY
OK


5. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)
  1. Disconnect the E80 ECU and E81 ECM connectors.

    1. Measure the resistance according to the value(s) in the table below.

      Standard resistance:
      Tester Connection
      Condition
      Specified Condition
      E80-12 (EFII) - E81-20 (IMO)
      Always
      Below 1 Ω
      E80-13 (EFIO) - E81-14 (IMI)
      Always
      Below 1 Ω
      E80-12 (EFII) - Body ground
      Always
      10 kΩ or higher
      E80-13 (EFIO) - Body ground
      Always
      10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


6. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


7. ECU CODE REGISTRATION
  1. Re-register the ECU communication ID between the transponder key ECU and ECM (Refer to the Service Bulletin).


NEXT


8. CHECK DTC OUTPUT
  1. Delete the DTC (Click here).

  1. Recheck for DTC (Click here).

    OK:
    DTC B2799 output does not reoccur.



NG
REPLACE TRANSPONDER KEY ECU
OK

END (ECM IS DEFECTIVE)


← B2799 Engine Immobiliser System Malfunction (Jul 2007 – Jul 2009)B279A Theft Deterrent System Communication Line High Fixation (Aug 2009 – Oct 2010) →