B279A Theft Deterrent System Communication Line High Fixation
Diagnostic trouble codes · Vehicles built Aug 2009 – Oct 2010
Versions by build date: Aug 2009 – Oct 2010 from Nov 2010
DESCRIPTION
If the communication line (EFIO-IMI) to the transponder key ECU assembly is stuck on HI output, the ECM outputs this DTC.| DTC No. |
DTC Detection Condition |
Trouble Area |
| B279A |
When communication line (EFIO-IMI) between ECM and the transponder key ECU is stuck on HI output |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
- If the ECM is replaced, register the ECU communication ID.
- If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
| 1. CHECK DTC OUTPUT |
Recheck for DTC (Click here).
- HINT:
- If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.
- Result:
Result
Proceed to
DTC B279A output reoccurs
A
DTC B279A and other DTCs output reoccur
B
|
|
||||
| A | |
| 2. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM) |
![]() ![]() |
Disconnect the E80 ECU and E81 ECM connectors.
Measure the resistance and voltage according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
E80-13 (EFIO) - E81-14 (IMI)
Always
Below 1 Ω
E80-13 (EFIO) - Body ground
Always
10 kΩ or higher
- Standard Voltage:
Tester Connection
Condition
Specified Condition
E80-13 (EFIO) - Body ground
Always
Below 1 V
|
|
||||
| OK | |
| 3. CHECK TRANSPONDER KEY ECU ASSEMBLY (OUTPUT) |
Reconnect the E80 ECU and E81 ECM connectors.
Measure the waveform.

Waveform 1 (Reference) Item
Content
Terminal No. (Symbols)
E80-13 (EFIO) - E80-16 (GND)
Tool Setting
5 V/DIV., 50 ms./DIV.
Condition
Ignition switch ON
Text in Illustration *1
Component with harness connected
(Transponder Key ECU Assembly)
|
|
||||
| OK | |
| 4. REPLACE TRANSPONDER KEY ECU ASSEMBLY |
Replace the transponder key ECU assembly (Refer to the Service Bulletin).
| NEXT | |
| 5. KEY REGISTRATION |
Register the key (Refer to the Service Bulletin).
| NEXT | |
| 6. ECU COMMUNICATION ID REGISTRATION |
Register the ECU communication ID (Refer to the Service Bulletin).
| NEXT | |
| 7. CHECK DTC OUTPUT |
Clear the DTCs (Click here).
Recheck for DTCs.
- OK:
- B279A output does not reoccur.
|
|
||||
| OK | ||
| ||

