2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Aug 2014

Versions by build date: Aug 2009 – Jul 2014 from Aug 2014


INSPECT AIR FUEL RATIO SENSOR (w/o Secondary Air Injection System)

  1. Check the resistance.

    1. A159233E24
      Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected:
      (Air Fuel Ratio Sensor)
      *b
      for Bank 1:
      *c
      for Bank 2:

      Standard Resistance (for Bank 1):
      Tester Connection
      Condition
      Specified Condition
      1 (HA1A) - 2 (+B)
      20°C (68°F)
      1.8 to 3.4 Ω
      1 (HA1A) - 4 (A1A-)
      Always
      10 kΩ or higher

      Standard Resistance (for Bank 2):
      Tester Connection
      Condition
      Specified Condition
      1 (HA2A) - 2 (+B)
      20°C (68°F)
      1.8 to 3.4 Ω
      1 (HA2A) - 4 (A2A-)
      Always
      10 kΩ or higher

      If the result is not as specified, replace the air fuel ratio sensor.


INSPECT AIR FUEL RATIO SENSOR (w/ Secondary Air Injection System)

  1. Check the resistance.

    1. A171118E01
      Measure the resistance according to the value(s) in the table below.
      Text in Illustration 
      *a
      Component without harness connected
      (Air Fuel Ratio Sensor)
      *b
      for Bank 1
      *c
      for Bank 2

      Standard Resistance (for Bank 1):
      Tester Connection
      Condition
      Specified Condition
      1 (HA1A) - 2 (+B)
      20°C (68°F)
      1.6 to 3.2 Ω
      1 (HA1A) - 4 (A1A-)
      Always
      10 kΩ or higher

      Standard Resistance (for Bank 2):
      Tester Connection
      Condition
      Specified Condition
      1 (HA2A) - 2 (+B)
      20°C (68°F)
      1.6 to 3.2 Ω
      1 (HA2A) - 4 (A2A-)
      Always
      10 kΩ or higher

      If the result is not as specified, replace the air fuel ratio sensor.

← INSPECTION (Aug 2009 – Jul 2014)INSTALLATION (Aug 2009 – Oct 2010) →