2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Aug 2009 – Oct 2010 Nov 2010 – Jul 2014 from Aug 2014


1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)

  1. A223685E02
    Using SST, tighten the air fuel ratio sensor.
    Text in Illustration 
    *a
    Fulcrum Length
    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.


2. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)

  1. A223683E02
    Using SST, tighten the air fuel ratio sensor.
    Text in Illustration 
    *a
    Fulcrum Length
    SST
    09224-00010  

    Torque:
    without SST:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }
    with SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }

    HINT:
    1. The "with SST" torque value is effective when using SST with a fulcrum length of 30 mm (1.18 in.).
    2. The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 300 mm (11.81 in.) (Click here).
    3. This torque value is effective when SST is parallel to the torque wrench.


3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY
  1. Install the exhaust manifold (Click here).

← INSPECTION (from Aug 2014)INSTALLATION (Nov 2010 – Jul 2014) →