2011-2016 FJ Cruiser · Service Manual STEERING

DISASSEMBLY

Removal / installation · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010


1. REMOVE TURN PRESSURE TUBE LH

  1. C234522
    Using a union nut wrench (12 mm), remove the turn pressure tube LH.

  1. Remove the 2 O-rings from the turn pressure tube LH.


2. REMOVE TURN PRESSURE TUBE RH

  1. C234523
    Using a union nut wrench (12 mm), remove the turn pressure tube RH.

  1. Remove the 2 O-rings from the turn pressure tube RH.


3. SECURE POWER STEERING LINK ASSEMBLY

  1. C234524E01
    Using SST wrapped in protective tape, secure the power steering link assembly in a vise.
    Text in Illustration 
    *1
    Protective Tape
    SST
    09612-00012  


4. REMOVE STEERING GEAR OUTLET RETURN TUBE

  1. C234525
    Using a union nut wrench (17 mm), remove the steering gear outlet return tube from the power steering link assembly.


5. REMOVE TIE ROD END SUB-ASSEMBLY LH

  1. F051688E02
    Put matchmarks on the tie rod end sub-assembly LH and the steering rack end sub-assembly.
    Text in Illustration 
    *a
    Matchmark
    *b
    Length A

  1. Measure length A and record the measurement.

  1. Remove the tie rod end sub-assembly LH.


6. REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure for the RH side as for the LH side.


7. REMOVE STEERING RACK BOOT CLIP (for LH Side)
  1. Using pliers, remove the steering rack boot clip.


8. REMOVE STEERING RACK BOOT CLIP (for RH Side)

HINT:
Use the same procedure for the RH side as for the LH side.


9. REMOVE STEERING RACK BOOT CLAMP (for LH Side)

C234526
  1. Using pliers, remove the steering rack boot clamp as shown in the illustration.

    NOTICE:
    Be careful not to damage the steering rack boot.


10. REMOVE STEERING RACK BOOT CLAMP (for RH Side)

HINT:
Use the same procedure for the RH side as for the LH side.


11. REMOVE NO. 2 STEERING RACK BOOT
  1. Remove the No. 2 steering rack boot.


12. REMOVE NO. 1 STEERING RACK BOOT

HINT:
Use the same procedure as for the No. 2 steering rack boot.


13. REMOVE STEERING RACK END SUB-ASSEMBLY (for LH Side)

  1. C234527E01
    Using SST, remove the steering rack end sub-assembly while holding the steering rack.
    Text in Illustration 
    *a
    Hold
    *b
    Turn
    SST
    09922-10010  

    NOTICE:
    1. Be sure to rotate SST in the correct direction.
    2. Be sure to keep the steering rack fixed in place with SST.


14. REMOVE STEERING RACK END SUB-ASSEMBLY (for RH Side)

  1. C234529E01
    Using SST, remove the steering rack end sub-assembly while holding the steering rack.
    Text in Illustration 
    *a
    Hold
    *b
    Turn
    SST
    09922-10010  

    NOTICE:
    1. Be sure to rotate SST in the correct direction.
    2. Be sure to keep the steering rack fixed in place with SST.

← DISASSEMBLY (Jul 2007 – Oct 2010)INSPECTION (Jul 2007 – Oct 2010) →