INSPECTION
Inspection · Vehicles built from Nov 2010
Versions by build date: Jul 2007 – Oct 2010 from Nov 2010
| INSPECT TIE ROD END SUB-ASSEMBLY LH |
![]() ![]() |
Secure the tie rod end sub-assembly LH in a vise.
- NOTICE:
- Do not overtighten the vise.
Install the nut to the stud bolt.
Flip the ball joint stud back and forth 5 times as shown in the illustration.
Set a torque wrench to the nut, turn the ball joint continuously at a rate of 2 to 4 seconds per turn, and check the turning torque on the 5th turn.
- Standard turning torque:
- 1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)
| INSPECT TIE ROD END SUB-ASSEMBLY RH |
- HINT:
- Use the same procedure for the RH side as for the LH side.
| INSPECT TOTAL PRELOAD |
Secure the power steering link assembly in a vise.
- NOTICE:
- Do not overtighten the vise.
Place matchmarks as shown in the illustration.

Text in Illustration *a
Matchmark
Temporarily install the 2 steering rack ends to the steering rack.
- NOTICE:
- Do not fully turn the steering rack without the steering rack ends installed as it may damage the oil seal in the rack housing.
Using SST, fully turn the steering rack right and left 1 to 2 times to settle it.

- SST
- 09616-00011
Using SST and a torque wrench, turn the steering pinion shaft and measure the preload.

- SST
- 09616-00011
- Standard preload:
- 1.6 to 2.3 N*m (16 to 23 kgf*cm, 14 to 20 in.*lbf)
- HINT:
- Measure the standard preload at the steering rack neutral point.
- The steering pinion shaft is fully turned when turned approximately 3 times. Half of the distance from the fully turned position is the neutral point.
- Measure the standard preload at the steering rack neutral point.
After inspecting the preload, align the matchmarks.

