2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Speed Signal Circuit

Circuit diagnosis · Vehicles built Aug 2009 – Oct 2010

Versions by build date: Jul 2007 – Jul 2009 Aug 2009 – Oct 2010 Nov 2010 – Jul 2011 Aug 2011 – Jul 2012 Aug 2012 – Oct 2012 from Nov 2012

CAUTION / NOTICE / HINT

HINT:
This procedure applies only for vehicles with rear fog lights.


DESCRIPTION

The clearance warning ECU receives the vehicle speed signal from the combination meter.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM

E130075E29

INSPECTION PROCEDURE


1. CHECK OPERATION OF SPEEDOMETER
  1. Drive the vehicle and check if the function of the speedometer in the combination meter is normal.

    OK:
    Actual vehicle speed and the speed indicated on the speedometer are the same.

    HINT:
    1. The speed indicated on the speedometer has an allowable margin of error. This can be tested using a speedometer tester (calibrated chassis dynamometer). For details about testing and the margin of error, refer to "ON-VEHICLE INSPECTION" in the meter/gauge system (Click here).
    2. The vehicle speed sensor is functioning normally when the indication on the speedometer is normal.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2. INSPECT COMBINATION METER ASSEMBLY (SPEED SIGNAL)

  1. E160749E01
    Disconnect the E76 clearance warning ECU connector.

  1. Jack up the drive wheels.

  1. Move the shift lever to N.

  1. Turn the ignition switch to ON.

  1. Using an oscilloscope, check the signal waveform of the meter.

    Reference 
    Terminal Connections
    E76-3(SPD) - Body ground
    Tester Range
    5 V/DIV., 20 msec./ DIV.
    Vehicle Condition
    Drive vehicle at 20 km/h (12 mph)

    HINT:
    As the vehicle speed increases, the wavelength shortens.

    OK:
    Voltage pulses as shown in the illustration

  1. Reconnect the clearance warning ECU connector.



NG
Go to step 3
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - COMBINATION METER ASSEMBLY)

  1. E160750E01
    Disconnect the E76 clearance warning ECU connector.

  1. Disconnect the E13 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E76-3 (SPD) - E13-4 (+S)
    Always
    Below 1 Ω
    E76-3 (SPD) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the clearance warning ECU connector.

  1. Reconnect the combination meter assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE COMBINATION METER ASSEMBLY (Click here)


← Speed Signal Circuit (Jul 2007 – Jul 2009)Speed Signal Circuit (Nov 2010 – Jul 2011) →