2011-2016 FJ Cruiser · Service Manual BRAKE

C1442 Invalid Data Received from Acceleration Sensor

Diagnostic trouble codes · Vehicles built Nov 2010 – Jul 2012

Also covers:

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

The skid control ECU receives signals from the yaw rate and deceleration sensor via the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1442
An invalid data signal is transmitted continuously from the deceleration sensor for 10 seconds or more
Yaw rate and deceleration sensor
C1443
An invalid data signal is transmitted continuously from the yaw rate sensor for 10 seconds or more
Yaw rate and deceleration sensor

INSPECTION PROCEDURE

NOTICE:
When replacing the yaw rate and deceleration sensor, perform zero point calibration (Click here).


1. CHECK DTC
  1. Turn the ignition switch off.

  1. Clear the DTC (Click here).

  1. Start and idle the engine for 60 seconds, and then stop the engine.

  1. Check if the same DTC is recorded (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE YAW RATE AND DECELERATION SENSOR (Click here)


← C1440/98 Steering Angle Sensor Unusual Bank Angle Detected (Aug 2009 – Oct 2010)C1442 Invalid Data Received from Acceleration Sensor (+ C1443) (from Aug 2012) →