2011-2016 FJ Cruiser · Service Manual BRAKE

C120A ECU Initial Setting Incomplete

Diagnostic trouble codes · Vehicles built from Aug 2012

Versions by build date: Nov 2010 – Jul 2012 from Aug 2012

DESCRIPTION

The skid control ECU (master cylinder solenoid) uses terminal NEO to determine the drive configuration of the skid control ECU (master cylinder solenoid).
DTC Code
DTC Detection Condition
Trouble Area
C120A
Open detected in Terminal NEO at IG ON
  1. Master cylinder solenoid (Skid control ECU)
  2. Harness or connector

WIRING DIAGRAM

C231262E02

INSPECTION PROCEDURE


1. INSPECT SKID CONTROL ECU (NEO TERMINAL)
  1. Disconnect the A4 skid control ECU connector.

  1. C213546E12
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A4-43 (NEO) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Skid Control ECU)



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2. CHECK FOR DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is recorded (Click here).

    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

REPLACE MASTER CYLINDER SOLENOID (Click here)


← C120A ECU Initial Setting Incomplete (Nov 2010 – Jul 2012)C1210 Zero Point Calibration of Yaw Rate Sensor Undone (+ C1336) (Nov 2010 – Jul 2011) →