2011-2016 FJ Cruiser · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Nov 2012


INSPECT FUEL SENDER GAUGE ASSEMBLY (for Fuel Main Tank)

  1. A294474E01
    Check that the float moves smoothly between the F level (upper end) and E level (lower end).
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sender Gauge Assembly)

  1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Float position is F (Upper end)
    6.5 to 8.5Ω
    Float position is E (Lower end)
    205.8 to 210.8 Ω

    If the value is not as specified, replace the fuel sender gauge assembly.


INSPECT FUEL SUB-TANK FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank)

  1. A294475E01
    Check that the float moves smoothly between the F level (upper end) and E level (lower end).
    Text in Illustration 
    *a
    Component without harness connected
    (Fuel Sub-Tank Fuel Sender Gauge Assembly)

  1. Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    Float position is F (Upper end)
    6.5 to 8.5Ω
    Float position is E (Lower end)
    199.2 to 204.2 Ω

    If the value is not as specified, replace the fuel sub-tank fuel sender gauge assembly.

← REMOVAL (from Nov 2012)INSTALLATION (from Nov 2012) →