2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2012


1. INSTALL FUEL SENDER GAUGE ASSEMBLY (for Fuel Main Tank)

  1. A294473
    As shown in the illustration, slide the claw downwards, and install the fuel sender gauge assembly to the No. 1 fuel sub tank.

  1. Connect the fuel sender gauge assembly connector.


2. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY (for Fuel Main Tank)
(Click here)

3. INSTALL FUEL SUB-TANK FUEL SENDER GAUGE ASSEMBLY (for Fuel Sub Tank)
  1. Install a new gasket to the fuel sub-tank fuel sender gauge assembly.

  1. Install the fuel sub-tank fuel sender gauge assembly to the fuel sub tank sub-assembly with the 5 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }

    NOTICE:
    Be careful not to bend the arm of the fuel sub-tank fuel sender gauge assembly.

  1. Connect the fuel sub-tank fuel sender gauge assembly connector.


4. INSTALL FUEL SUB TANK SUB-ASSEMBLY (for Fuel Sub Tank)
(Click here)
← INSPECTION (from Nov 2012)PARTS LOCATION (Jul 2007 – Jul 2009) →