2011-2016 FJ Cruiser · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Nov 2012


1. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
  1. Install the fuel suction tube set gasket to the fuel tank assembly.

  1. Set the fuel suction tube with pump and gauge assembly to the fuel tank.

    NOTICE:
    Make sure that the fuel sender gauge assembly arm does not bend.

  1. A294481E01
    Align the protrusions of the fuel suction tube with pump and gauge assembly with the groove of the fuel tank assembly.
    Text in Illustration 
    *a
    Protrusion
    *b
    Groove

  1. A294482E01
    While holding the fuel suction tube with pump and gauge assembly by hand to prevent it from tilting, align the mark on a new fuel pump gauge retainer with the start mark on the fuel tank assembly and tighten the fuel pump gauge retainer 180° by hand.
    Text in Illustration 
    *a
    Start Mark (Fuel Tank Side)
    *b
    Mark (Retainer Side)

    HINT:
    Check that there is no damage, dents, foreign matter or other defects on the threads of the fuel tank assembly.

  1. Temporarily install the SST plate and claws to the fuel pump gauge retainer.

    SST
    09808-14030   (09808-01030, 09808-01040, 09808-01050)

    HINT:
    Engage the SST claws securely with the fuel pump gauge retainer ribs to secure SST.

  1. While pressing the claws of SST to the fuel pump gauge retainer ribs securely, tighten the bolts.

    HINT:
    Install SST while pressing the SST claws toward the fuel pump gauge retainer (towards the center of SST).

  1. Install the SST handle to the SST plate.

  1. A294483E01
    Tighten the fuel pump gauge retainer approximately 360° so that the mark on the fuel pump gauge retainer comes within the range shown in the illustration.
    Text in Illustration 
    *1
    SST (Handle)
    *2
    SST (Plate)
    *3
    SST (Claw)
    *a
    Mark (Retainer Side)
    SST
    09808-14030   (09808-01010, 09808-01020, 09808-01030, 09808-01040, 09808-01050)

    NOTICE:
    1. Do not use any tools other than specified in this operation. Damage to the fuel pump gauge retainer or the fuel tank assembly may result.
    2. Do not press down on SST excessively as this may make the retainer hard to rotate, and may damage components.
    3. Make sure to rotate the SST handle horizontally. If the SST handle is rotated at an angle, SST may come off.
    4. Do not spin SST too fast or use an impact wrench as this may result in damage to components.
    5. If SST comes off of the fuel pump gauge retainer, loosen the SST bolts and reinstall SST.

    HINT:
    1. Lightly press down on SST to prevent it from separating from the fuel pump gauge retainer. While pressing SST, rotate the handle slowly to tighten the fuel pump gauge retainer.
    2. The ribs on the fuel pump gauge retainer can be fitted into the tips of SST.


2. INSTALL FUEL TANK ASSEMBLY
(Click here)
← REASSEMBLY (from Nov 2012)COMPONENTS (Jul 2007 – Jul 2009) →