2011-2016 FJ Cruiser · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Nov 2012


1. REMOVE FUEL TANK ASSEMBLY
(Click here)

2. REMOVE FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY

  1. A294470E01
    Temporarily install the SST plate and claws to the fuel pump gauge retainer.
    Text in Illustration 
    *1
    SST (Plate)
    *2
    SST (Claw)
    *3
    Rib
    V100135
    Push
    SST
    09808-14030   (09808-01030, 09808-01040, 09808-01050)

    HINT:
    Engage the SST claws securely with the fuel pump gauge retainer ribs to secure SST.

  1. While pressing the claws of SST to the fuel pump gauge retainer ribs securely, tighten the bolts.

    HINT:
    Install SST while pressing the SST claws toward the fuel pump gauge retainer (towards the center of SST).

  1. Install the SST handle to the SST plate.

  1. A294471E01
    Lightly press down on SST to prevent it from separating from the fuel pump gauge retainer. While pressing SST, rotate the handle slowly to loosen the fuel pump gauge retainer.
    Text in Illustration 
    *1
    SST (handle)
    *2
    SST (Plate)
    *3
    SST (Claw)
    SST
    09808-14030   (09808-01010, 09808-01020, 09808-01030, 09808-01040, 09808-01050)

    NOTICE:
    1. Do not use any tools other than specified in this operation. Damage to the fuel pump gauge retainer or the fuel tank may result.
    2. Do not press down on SST excessively as this may make the fuel pump gauge retainer hard to rotate, and may damage components.
    3. Make sure to rotate the SST handle horizontally. If the SST handle is rotated at an angle, SST may come off.
    4. Do not spin SST too fast or use an impact wrench as this may result in damage to components.
    5. If SST comes off of the fuel pump gauge retainer, loosen the SST bolts and reinstall SST.

    HINT:
    The ribs on the fuel pump gauge retainer can be fitted into the tips of SST.

  1. Remove the fuel pump gauge retainer while holding the fuel suction tube with pump and gauge assembly by hand.

  1. A294476
    Remove the fuel suction tube with pump and gauge assembly from the fuel tank assembly.

    NOTICE:
    Make sure that the fuel sender gauge assembly arm does not bend.

  1. A294477E01
    Remove the fuel suction tube set gasket from the fuel tank assembly.
    Text in Illustration 
    *1
    Fuel Suction Tube Set Gasket

← COMPONENTS (from Nov 2012)DISASSEMBLY (from Nov 2012) →