Home › ENGINE › 1GR-FE FUEL › FUEL INJECTOR

FUEL INJECTOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL INJECTOR ASSEMBLY


    A223045E02
  1. Install a new insulator onto each fuel injector.
    Text in Illustration 
    *1
    New Insulator
    *2
    New O-Ring

  1. Apply a light coat of spindle oil or gasoline to each new O-ring and install one onto each fuel injector.



    A223046E02
  1. Install the 6 injectors.
    Text in Illustration 
    *1
    Connector
    V100135
    Outward
    V100136
    Turn
    V100137
    Push

    1. While turning each fuel injector left and right, install it onto the fuel delivery pipe.

      HINT:
      Perform "Inspection After Repairs" after replacing the fuel injector assembly (Click here).

    2. Position the fuel injector connectors facing outward.



2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY


    A223047E02
  1. Place the fuel delivery pipe together with the 6 fuel injectors on the intake manifold.
    Text in Illustration 
    *a
    Turn

  1. Temporarily install the 6 bolts, which are used to hold the fuel delivery pipe, to the intake manifold.

  1. Check that the fuel injectors rotate smoothly.

    HINT:
    If the fuel injectors do not rotate smoothly, replace the O-ring of any injector that does not rotate smoothly.

  1. Position the fuel injector connectors facing outward.

  1. Tighten the 6 bolts, which are used to hold the fuel delivery pipe, to the intake manifold.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the 6 fuel injector connectors.



3. CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY
  1. Connect the No. 2 fuel pipe sub-assembly (Click here).

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. If the pipe is difficult to push into the connector, apply a small amount of clean engine oil to the tip of the pipe and reinsert it.
    3. After connecting, check that the pipe and connector are securely connected by pulling on them.



4. CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
  1. Connect the No. 1 fuel pipe sub-assembly (Click here).

    NOTICE:
    1. Check that there are no scratches or foreign objects on the connecting part.
    2. If the pipe is difficult to push into the connector, apply a small amount of clean engine oil to the tip of the pipe and reinsert it.
    3. After connecting, check that the pipe and connector are securely connected by pulling on them.



5. INSTALL REAR CYLINDER HEAD COVER
  1. Temporarily install the cover with the 3 bolts.



    A224695E01
  1. Tighten the 3 bolts in the sequence shown in the illustration.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }



6. INSTALL INTAKE AIR SURGE TANK
  1. Install the intake air surge tank (Click here).



7. INSPECT FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

    NOTICE:
    Do not start the engine.

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump Speed / ON.

  1. Check fuel pump operation.

    1. Check for pressure in the fuel inlet tube from the fuel line. Check that the sound of fuel flowing in the fuel tank can be heard.
      If there is no sound, check the integration relay, fuel pump, ECM and wiring connector.