FRONT PASSENGER AIRBAG ASSEMBLY > DISPOSAL |
| 1. DISPOSE OF FRONT PASSENGER AIRBAG ASSEMBLY (WHEN INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Precaution (Click here).
Disconnect the cable from the negative battery terminal.
Remove the glove compartment door assembly .
Remove the instrument panel lower finish panel sub-assembly RH .
Install the SST.
![]() |
Disconnect the airbag connector.
![]() |
Connect the SST connector to the instrument panel wire assembly.
![]() |
Move SST at least 10 m (33 ft) away from the vehicle side window.
Securing enough clearance for the SST wire harness in the side window, close all doors and windows of the vehicle.
Connect the red clip of the SST to the positive (+) battery terminal and the black clip of the SST to the negative (-) terminal.
Deploy the airbag.
Check that no one is inside the vehicle or within a 10 m (33 ft) radius of the vehicle.
Press the SST activation switch and deploy the airbag.
| 2. DISPOSE OF FRONT PASSENGER AIRBAG ASSEMBLY (WHEN NOT INSTALLED IN VEHICLE) |
![]() |
Check the function of SST (Click here).
Remove the front passenger airbag assembly (Click here).
Install SST.
![]() |
After connecting SST below to each other, connect them to the front passenger airbag assembly.
![]() |
Using a service-purpose wire harness for the vehicle, tie down the front passenger airbag assembly to the tire.
| Area | Measurement |
| A | 1.25 mm2 or more (0.0019 in.2 or more) |
Position the front passenger airbag assembly inside the tire with the airbag deployment side facing inside.
| Area | Measurement |
| Width | 185 mm (7.28 in.) |
| Inner diameter | 360 mm (14.17 in.) |

![]() |
Place the tires.
Place at least 2 tires under the tire to which the front passenger airbag assembly is tied.
Place at least 2 tires over the tire to which the front passenger airbag assembly is tied. The top tire should have a disc wheel installed.
![]() |
Tie the tires together with 2 wire harnesses.
Install SST.
![]() |
Connect the SST connector.
Move SST at least 10 m (33 ft) away from the airbag tied down to the tire.
Deploy the airbag.
Connect the red clip of the SST to the positive (+) battery terminal and the black clip of the SST to the negative (-) battery terminal.
Check that no one is within a 10 m (33 ft) radius of the tire to which the front passenger airbag assembly is tied.
Press the SST activation switch and deploy the airbag.
![]() |
Dispose of the front passenger airbag assembly.
Remove the front passenger airbag assembly from the tire.
Place the front passenger airbag assembly in a plastic bag, tie it tightly and dispose of in the same way as other general parts.