Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2194/94    Engine Speed Signal Error (Test Mode DTC)

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives an engine speed signal from the ECM. This DTC is stored upon entering test mode, and cleared when an engine speed signal of 1000 rpm or more is detected for 3 seconds or more. This DTC is output only in test mode.

DTC No.
DTC Detection Condition
Trouble Area
C2194/94
Engine speed signal circuit malfunction
  1. ECM
  2. Harness or connector
  3. Tire pressure warning ECU

WIRING DIAGRAM


C243848E04


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using a Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

1.READ VALUE USING TECHSTREAM (ENGINE SPEED)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  1. Check that the values indicated on the Techstream and on the combination meter assembly are the same.

    Tire Pressure Monitor 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Engine Speed
    Engine speed/
    min.: 0 rpm
    max.: 65535 rpm
    Actual engine speed
    Engine speed indicated on the combination meter assembly

    OK:
    Engine speed indicated on the tester and on the combination meter assembly are the same.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.INSPECT TIRE PRESSURE WARNING ECU (TACH SIGNAL)


    C162301E54
  1. Disconnect the E74 tire pressure warning ECU connector.

  1. Start the engine.

  1. Check the waveform of the ECU connector using an oscilloscope, while idling the engine.

    OK:
    Tester Connection
    Condition
    Specified Condition
    E74-4 (TACH) - E74-9 (GND)
    Idling
    Correct waveform is as shown

    Text in Illustration 
    *a
    Rear view of wire harness connector
    (to Tire Pressure Warning ECU)
    Tool Setting 
    Item
    Contents
    Terminal No. (Symbols)
    E74-4 (TACH) - E74-9 (GND)
    Tool Setting
    5 V/DIV., 10 ms/DIV.
    Vehicle Condition
    Idling

    HINT:
    The wavelength becomes shorter as the engine speed increases.



NG
Go to step 3
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)  

3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING ECU - ECM)
  1. Disconnect the E74 tire pressure warning ECU connector.

  1. Disconnect the E77 ECM connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E74-4 (TACH) - E77-29 (TACH)
    Always
    Below 1 Ω
    E74-4 (TACH) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE ECM (Click here)