Home › DRIVE LINE ยท DIFFERENTIAL › DIFFERENTIAL CARRIER ASSEMBLY (w/ Differential Lock)

DIFFERENTIAL CARRIER ASSEMBLY (w/ Differential Lock) > INSTALLATION

for Preparation Click here



1. INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY
  1. Remove any dust and oil from the differential carrier assembly and the contact surfaces of the axle housing.

  1. Apply liquid gasket to both sides of a new gasket.

    NOTICE:
    Do not apply the liquid gasket to the stud bolt.

  1. Install a new gasket and the differential carrier assembly with the 11 nuts and 11 washers.

    Torque:
    52 N*m{ 530 kgf*cm , 38 ft.*lbf }

  1. Connect the differential lock actuator connector.

  1. Connect the rear differential lock actuator breather hose to the differential actuator assembly.



2. INSTALL REAR AXLE SHAFT LH
  1. Install the rear axle shaft LH (Click here).



3. INSTALL REAR AXLE SHAFT RH

HINT:
Use the same procedure as for the LH side.



4. INSTALL REAR PROPELLER SHAFT ASSEMBLY
  1. Install the rear propeller shaft assembly (Click here).