Home › BODY › WINDSHIELD / WINDOWGLASS › POWER WINDOW CONTROL SYSTEM

POWER WINDOW CONTROL SYSTEM > Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch

for Preparation Click here


DESCRIPTION

If the front passenger side manual UP / DOWN functions do not operate, a malfunction may be present in the power window regulator master switch, power window regulator motor, power window regulator switch or wire harness.

WIRING DIAGRAM


B294023E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - POWER RELAY)


    B290930E01
  1. Disconnect the G6 power window regulator switch assembly connector.

  1. Turn the ignition switch to ON.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    G6-3 (B) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY
  1. Inspect the power window regulator switch assembly (Click here).



NG
REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (Click here)
OK


3.INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH
  1. Inspect the power window regulator motor assembly RH (Click here).



NG
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH - POWER WINDOW REGULATOR MOTOR RH)
  1. Disconnect the G6 power window regulator switch assembly connector.

  1. Disconnect the G3 power window regulator motor assembly RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G6-1 (D) - G3-1 (D)
    Always
    Below 1 Ω
    G6-4 (U) - G3-2 (U)
    Always
    Below 1 Ω
    G6-1 (D) or G3-1 (D) - Body ground
    Always
    10 kΩ or higher
    G6-4 (U) or G3-2 (U) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - POWER WINDOW REGULATOR SWITCH)
  1. Disconnect the H7 power window regulator master switch assembly connector.

  1. Disconnect the G6 power window regulator switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H7-18 (D) - G6-2 (SD)
    Always
    Below 1 Ω
    H7-16 (U) - G6-5 (SU)
    Always
    Below 1 Ω
    H7-18 (D) or G6-2 (SD) - Body ground
    Always
    10 kΩ or higher
    H7-16 (U) or G6-5 (SU) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (Click here)