Home › ENGINE › 1GR-FE FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
  1. Discharge the fuel system pressure (Click here).



2. REMOVE INTAKE AIR SURGE TANK
  1. Remove the intake air surge tank (Click here).



3. DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY


    A223036
  1. Disconnect the No. 2 fuel pipe sub-assembly (Click here).

    NOTICE:
    1. Check for dirt or other foreign matter on the parts to be disconnected and clean them if necessary.
    2. The fuel tube connector seals with an O-ring. Ensure that there is no damage or foreign matter on the contact surface.
    3. If the connector and the pipe are stuck, push and pull on the connector to release them while pinching the retainer. Pull the connector out of the pipe carefully.
    4. Do not use any tools.
    5. Do not bend or twist the tubes.
    6. Protect the contact surface by covering it with a plastic bag.
    7. Do not damage any of the clips. If a clip is damaged, replace it.



4. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


    A223049
  1. Disconnect the vacuum hose.

  1. Remove the 2 bolts and fuel pressure regulator.

  1. Remove the O-ring from the fuel pressure regulator.