Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > VSC Buzzer Circuit

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.
The combination meter has a built-in skid control buzzer.
Sounds intermittently to inform driver if temperature of hydraulic brake booster has increased excessively due to continuous operation of TRAC, A-TRAC, AUTO LSD and CRAWL.
Sounds continuously to alert driver that hydraulic pressure of accumulator in hydraulic brake booster has decreased, or during CRAWL operation, to alert driver that CRAWL operating conditions are no longer being met.

WIRING DIAGRAM


C231258E01


INSPECTION PROCEDURE

NOTICE:
When replacing the master cylinder solenoid, perform the zero point calibration (Click here).

1.CHECK CAN COMMUNICATION LINE
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Select CAN Bus Check from the System Selection Menu screen and follow the prompts on the screen to inspect the CAN bus (Click here).

    OK:
    CAN Bus Check indicates no malfunctions in CAN communication.



NG
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) (Click here)
OK


2.PERFORM ACTIVE TEST USING TECHSTREAM (BUZZER)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

  1. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer OFF/ON
    Buzzer can be heard

  1. Check that the buzzer sounds or stops in accordance with the Techstream.
    Result 
    Result
    Proceed to
    Buzzer does not sound or stop
    A
    Buzzer sounds and stops
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3.REPLACE COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Replace the combination meter (Click here).


NEXT


4.PERFORM ACTIVE TEST USING TECHSTREAM (BUZZER)
  1. Turn the ignition switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

  1. According to the display on the tester, perform the Active Test.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Buzzer
    Skid control buzzer
    Buzzer OFF/ON
    Buzzer can be heard

  1. Check that the buzzer sounds or stops in accordance with the Techstream.
    Result 
    Result
    Proceed to
    Buzzer does not sound or stop
    A
    Buzzer sounds and stops
    B



B
END
A

REPLACE MASTER CYLINDER SOLENOID (Click here)