Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2796    No Communication in Immobiliser System

DTC    B2798    Communication Malfunction No. 2

for Preparation Click here


DESCRIPTION

These DTCs are output if a key that does not have a transponder chip is inserted into the ignition key cylinder or if communication between the key and transponder key ECU is impossible.

DTC No.
DTC Detection Condition
Trouble Area
B2796
The key code cannot be transmitted
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU
B2798
Key code identification cannot be completed within the specified time (0.15 to 0.5 seconds.)
  1. Key
  2. Transponder key amplifier
  3. Transponder key ECU

WIRING DIAGRAM


B164252E25


INSPECTION PROCEDURE

NOTICE:
  1. If the transponder key ECU assembly is replaced, register the key and ECU communication ID.
  2. If the key is replaced, register the key.

1.READ VALUE USING TECHSTREAM
  1. Connect a Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester ON.

  1. Enter the following menus: Body Electrical / Immobiliser / Data List.

  1. According to the display on tester, read the "Data List".


Immobiliser: 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Immobiliser
Immobiliser system status/SET or UNSET
UNSET: Ignition switch ON
SET: Without key
-

OK:
UNSET (Ignition switch ON) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU (Click here)  

2.CHECK KEYS
  1. Insert the vehicle's other key into the ignition key cylinder.

  1. Check that the engine starts with this key.

    OK:
    The engine starts.



NG
Go to step 3
OK

RE-REGISTER OR REPLACE KEY THAT CANNOT START ENGINE 

3.REPLACE TRANSPONDER KEY AMPLIFIER
  1. Replace the transponder key amplifier (Click here).


NEXT


4.CHECK ENGINE START
  1. Check that the engine starts.

    OK:
    The engine starts.



NG
REPLACE TRANSPONDER KEY ECU (Click here)
OK

END (TRANSPONDER KEY AMPLIFIER IS DEFECTIVE)