Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

ENGINE IMMOBILISER SYSTEM > Security Indicator Light Circuit

for Preparation Click here


DESCRIPTION

When the transponder key is registered, the transponder key ECU assembly outputs the key registration condition by lighting up, blinking or turning off the security indicator.

WIRING DIAGRAM


B175678E03


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester ON.

  1. Enter the following menus: Body Electrical / Immobiliser / Active Test.

  1. Perform the Active Test according to the display on the tester.


Immobiliser: 
Tester Display
Test Part
Control Range
Diagnostic Note
Security Indic
Turn security indicator
ON/OFF
-

OK:
The security indicator turns on and off according to the tester operation.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - SECURITY INDICATOR LIGHT)
B175679E03
  1. Disconnect the E79 transponder key ECU connectors.

  1. Disconnect the E32 air conditioning control connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E79-8 (IND) - E32-15 (LP)
    Always
    Below 1 Ω
    E79-8 (IND) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the transponder key ECU connectors.

  1. Reconnect the air conditioning control connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - BODY GROUND)
B175680E01
  1. Disconnect E32 air conditioning control connector.

  1. Measure the resistance according to the value(s) in the table below.

Standard resistance:
Tester Connection
Condition
Specified Condition
E32-20 (E) - Body ground
Always
Below 1 Ω

  1. Reconnect the air conditioning control connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.INSPECT TRANSPONDER KEY ECU
B128338E69
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E79-8 (IND) - Body ground
    Immobiliser set state
    (No key is in ignition key cylinder)
    Repeats 11 to 14 V and below 1 V



NG
REPLACE AIR CONDITIONING CONTROL (Click here)
OK

REPLACE TRANSPONDER KEY ECU (Click here)