Home › SECURITIES › ENGINE IMMOBILISER › ENGINE IMMOBILISER SYSTEM

DTC    B2784    Antenna Coil Open / Short

for Preparation Click here


DESCRIPTION

The transponder key coil is built into the transponder key amplifier and receives a key code signal from the transponder chip in the key. This signal is amplified by the amplifier, then it is output to the transponder key ECU.

DTC No.
DTC Detection Condition
Trouble Area
B2784
Antenna coil is open/shorted
  1. Wire harness
  2. Transponder key amplifier
  3. Transponder key ECU

WIRING DIAGRAM


B164252E24


INSPECTION PROCEDURE

NOTICE:
If the transponder key ECU is replaced, register the key and ECU communication ID.

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the tester ON.

  1. Enter the following menus: Body Electrical / Immobiliser / Data List.

  1. According to the display on tester, read the "Data List".


Immobiliser: 
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Antenna Coil Status
Transponder key amplifier coil condition/NORMAL or FAIL
NORMAL: Antenna coil is normal
FAIL: Antenna coil is malfunctioning
-

OK:
NORMAL (Antenna coil is normal) appears on the screen.



NG
Go to step 2
OK

REPLACE TRANSPONDER KEY ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)


    B151012E16
  1. Disconnect the E79 transponder key ECU connectors.

  1. Disconnect the E72 transponder key amplifier connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E79-4 (TXCT) - E72-5 (TXCT)
    Always
    Below 1 Ω
    E79-5 (AGND) - E72-7 (AGND)
    Always
    Below 1 Ω
    E79-14 (VC5) - E72-1 (VC5)
    Always
    Below 1 Ω
    E79-15 (CODE) - E72-4 (CODE)
    Always
    Below 1 Ω
    E79-4 (TXCT) - Body ground
    Always
    10 kΩ or higher
    E79-5 (AGND) - Body ground
    Always
    10 kΩ or higher
    E79-14 (VC5) - Body ground
    Always
    10 kΩ or higher
    E79-15 (CODE) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT TRANSPONDER KEY ECU (TRANSPONDER KEY AMPLIFIER POWER SOURCE)
B128338E67
  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E79-14 (VC5) - Body ground
    No key is in ignition key cylinder
    Below 1 V
    Key is in ignition key cylinder
    4.6 to 5.4 V



NG
REPLACE TRANSPONDER KEY ECU (Click here)
OK


4.INSPECT TRANSPONDER KEY ECU (TRANSPONDER KEY AMPLIFIER GROUND)


    B128338E68
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E79-5 (AGND) - Body ground
    Always
    Below 1 Ω



NG
REPLACE TRANSPONDER KEY ECU (Click here)
OK

REPLACE TRANSPONDER KEY AMPLIFIER (Click here)