CAN COMMUNICATION SYSTEM > Open in CAN Main Bus Line |
| Symptom | Trouble Area |
| Resistance between terminals 6 (CANH) and 14 (CANL) of DLC3 is 70 Ω or higher. |
|

| 1.PRECAUTION |
| NEXT | |
| 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.
| NEXT | |
| 3.CHECK DLC3 |
Disconnect the CAN junction connector connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E1-6 (CANH) - E86-4 (CANH) | Ignition switch off | Below 1 Ω |
| E1-14 (CANL) - E86-15 (CANL) | Ignition switch off | Below 1 Ω |
| *a | Front view of DLC3 |
| *b | Rear view of wire harness connector (to CAN Junction Connector) |
|
| ||||
| OK | |
| 4.CHECK FOR OPEN IN CAN BUS MAIN WIRE (CAN JUNCTION CONNECTOR - ECM) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E86-1 (CANH) - E86-12 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Rear view of wire harness connector (to CAN Junction Connector) |
|
| ||||
| OK | |
| 5.CHECK FOR OPEN IN CAN BUS MAIN WIRE (CAN JUNCTION CONNECTOR - COMBINATION METER ASSEMBLY (COMBINATION METER ECU) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E86-3 (CANH) - E86-14 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Rear view of wire harness connector (to CAN Junction Connector) |
|
| ||||
| OK | ||
| ||
| 6.CONNECT CONNECTOR |
Reconnect the E86 CAN junction connector connector.
| NEXT | |
| 7.CHECK FOR OPEN IN CAN BUS MAIN WIRE (ECM - CAN JUNCTION CONNECTOR) |
![]() |
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E77-32 (CANH) - E77-31 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 8.CONNECT CONNECTOR |
Reconnect the E86 CAN junction connector connector.
| NEXT | |
| 9.CHECK FOR OPEN IN CAN BUS MAIN WIRE (COMBINATION METER ASSEMBLY (COMBINATION METER ECU) - CAN JUNCTION CONNECTOR) |
![]() |
Disconnect the combination meter connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E14-10 (CANH) - E14-9 (CANL) | Ignition switch off | 108 to 132 Ω |
| *a | Front view of wire harness connector (to Combination Meter Assembly (Combination Meter ECU)) |
|
| ||||
| OK | ||
| ||