AUDIO AND VISUAL SYSTEM > Mute Signal Circuit between Radio Receiver and Multi-media Interface ECU |

| 1.INSPECT RADIO RECEIVER ASSEMBLY |
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E84-6 (MUTE) - Body ground | Ignition switch ACC, USB audio system is playing → Mode is changing | Above 2.5 V → Below 0.5 V |
| *a | Component with harness connected (Radio Receiver Assembly) |
|
| ||||
| OK | ||
| ||
| 2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - MULTI-MEDIA INTERFACE ECU) |
Disconnect the E84 radio receiver assembly and E82 multi-media interface ECU connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E84-6 (MUTE) - E82-6 (MUT1) | Always | Below 1 Ω |
| E84-6 (MUTE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT MULTI-MEDIA INTERFACE ECU |
![]() |
Reconnect the E82 multi-media interface ECU connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| E82-6 (MUT1) - Body ground | Ignition switch ACC | Above 2.5 V |
| *a | Component with harness connected (Multi-media Interface ECU) |
|
| ||||
| OK | ||
| ||